Telehandler
Best for construction sites. It handles rough ground, lifts to about 54 ft and reaches out over obstacles.
See the telehandlerMerlo 40.17 telehandler
Location Ferrento rents the Merlo 40.17 telehandler to contractors across Montreal. It's rated for 5,500 lb, lifts to about 54 ft and reaches out roughly 41 ft, so you can set pallets on a roof, a scaffold or an upper floor without bringing in a crane. Rent it by the day, week or month, and we'll deliver it to your site from our yard in LaSalle.
$595 a day, $1,725 a week, $5,250 a month. Questions about your lift? Send us a message.
The machine
A telehandler is part forklift, part crane. Instead of a mast that goes straight up, it has a telescopic boom that extends up and out, so it can lift a load high and set it down well past the front of the machine. That's why it's the machine of choice on roofing, framing and masonry jobs, where material has to go up and over.
The Merlo 40.17 is a full-size telehandler built for that kind of work. Front stabilizers come down for high and long-reach lifts, and the boom side-shift lets the operator line up a load left or right without moving the whole machine. Merlo's load control system keeps an eye on stability and limits boom movement as a lift gets close to the machine's limits.
How much it can lift depends on where the boom is. A telehandler carries its heaviest loads with the boom low and close in, and capacity drops as the boom extends. The load chart in the cab shows what the machine can handle at each height and reach, so check it before every lift.
| Model | Merlo 40.17 |
|---|---|
| Rated capacity | 5,500 lb |
| Maximum lift height | About 54 ft (16.6 m) |
| Maximum forward reach | About 41 ft (12.5 m) |
| Stabilizers | Yes, front stabilizers |
| Boom side-shift | Yes |
| Operating weight | About 25,700 lb (11.7 t) |
| Width | About 7 ft 11 in (2.42 m) |
| Height | About 8 ft 2 in (2.5 m) |
Reach, weight and dimensions are Merlo's figures for the 40.17 and can vary slightly by model year. Call us if you need exact numbers for a lift plan.
Typical jobs
If material has to go up, over something or across rough ground, a telehandler usually gets it there faster than a forklift and for less than a crane. These are the jobs telehandlers are rented for most often.
Lifting bundles of shingles, membrane rolls and roofing supplies straight up to the roof deck.
Setting lumber packs, beams and sheathing on upper floors as the building goes up.
Placing pallets of brick, block and mortar on scaffolding so the crew never runs short of material.
Loading gyproc, windows and doors through upper floor openings instead of carrying them up the stairs.
Unloading flatbeds on gravel, mud or uneven ground where a warehouse forklift would get stuck.
Placing loads over fences, trenches or a lower roof line without driving up to the building.
Pricing
Rates are for the rental only. Delivery and taxes are extra. A week costs less than three days, so if the job could run past day two, the weekly rate is usually the better deal.
| Equipment | Day | Week | Month | Link |
|---|---|---|---|---|
| Merlo 40.17 telehandler, 5,500 lb | $595 | $1,725 | $5,250 | Check availability |
| Rotary attachment for the Merlo 40.17 | $110 | $215 | $580 | Check availability |
The rotary attachment is made for the Merlo 40.17. It lets the operator turn the load at the end of the boom, which helps when material has to go into a tight spot or sit at an angle. Not sure your job needs it? Ask when you book and our counter staff will tell you.
Our material handling section also has propane forklifts, pallet trucks, fork extensions and forklift hoppers for jobs that don't need the height or reach of a telehandler.
Choosing the right machine
All three move pallets, but they're built for very different jobs. Picking the right one saves money and keeps the work moving.
Best for construction sites. It handles rough ground, lifts to about 54 ft and reaches out over obstacles.
See the telehandlerBest for flat, hard surfaces like yards, warehouses and loading docks. It lifts loads up to 15 ft and runs on propane.
See the forkliftBest for moving pallets across smooth floors at ground level, in a warehouse, a shop or a store.
See the pallet truckNot sure which one fits? Call us at (514) 363-4426 and describe the job.
Before you rent
A telehandler is a big machine, and lift truck safety rules in Quebec are strict. Here's what to have in place before it shows up on site.
Quebec's workplace safety regulation (RSST, section 256.3) requires lift truck operators to have both theory and hands-on training.
Telehandler training is a separate course from regular forklift training, so make sure whoever runs the Merlo has been trained on a telehandler. Courses are offered by safety training providers across the Montreal area.
Walk the area before the first lift. The ground should be firm and as level as possible, overhead power lines should be well clear, and nobody should stand under or near a raised load.
Put the stabilizers down for high or long-reach lifts, and check the load chart every time the load or the boom position changes.
The Merlo weighs about 25,700 lb and is close to 8 ft wide, so it arrives on a trailer. Leave room for the truck to pull in and unload, and plan a solid path to where the machine will work.
Check that gates and openings along the way are wider than the machine.
Delivery
Most customers have the telehandler delivered. At close to 26,000 lb, it needs a heavy trailer and a truck rated to pull it, so delivery is simpler and safer than hauling it yourself. We bring it from our yard at 7360 Boulevard Newman in LaSalle and pick it up when the job is done. Delivery is quoted based on where your site is, so ask for the price when you book.
We also deliver to many areas off the island, including Laval, Longueuil and Brossard. Call to confirm your address.
See how our equipment rental delivery works, or stop by our tool rental shop in LaSalle to talk the job over at the counter.
FAQs
Our Merlo 40.17 telehandler rents for $595 a day, $1,725 a week or $5,250 a month. Delivery and taxes are extra, and the rotary attachment adds $110 a day.
It lifts to about 54 ft (16.6 m) and reaches about 41 ft (12.5 m) forward. How much it can carry at those positions is shown on the load chart in the cab.
The Merlo is rated for 5,500 lb. The safe load changes with how high and how far out the boom is, so check the load chart before every lift.
A forklift lifts straight up on a mast and works best on flat, hard surfaces. A telehandler has a telescopic boom that reaches up and out, and it's built for rough construction sites. If you need to lift onto a roof or over something, you need a telehandler. For yard and warehouse work, a forklift costs less.
Yes. Quebec's RSST (section 256.3) requires lift truck operators to have theory and practical training. Make sure the operator has been trained on a telehandler specifically, not only on a regular forklift.
Yes. We deliver across Montreal from our LaSalle yard and pick the machine up at the end of the rental. See how our equipment rental delivery works.
Don't lift people on the forks or on a pallet. For work at height, rent a scissor lift or boom lift, which are built to carry workers.
Our rental contract requires renters to carry all-risk insurance on the rented equipment. Call the counter if you have questions about coverage.
Telescopic forklift, telescopic handler, reach forklift, zoom boom or lull. In French it's usually called a télescopique or a chariot élévateur télescopique. Our catalog lists the Merlo as Forklift Telescopic 5500 lbs.
As early as you can, especially between spring and fall. Check availability online or call us at (514) 363-4426.
Book the Merlo 40.17 online or call the counter and we'll set up delivery to your job.
Have a question first? Contact us. Contractors who rent regularly can apply for an account.